5A4-64 ANTI-LOCK BRAKE SYSTEM (ABS) Removal Inspection and Repair 1. Check the speed sensor for presence of foreign materials; remove any dirt, etc. 2. Check the speed sensor for damage, and replace the speed sensor if necessary. 3. Check the speed sensor harness for a short or an open, and replace with a new one if necessary. To check for harness short or open, bend or stretch the cable while checking for continuity. Installation 1. Install speed sensor bracket and tighten the nut to the specified torque. Torque: GVW Range 12,000 lbs. and 14,500 lbs. model 108 N m (11kgf m/80lb ft) GVW Range 17,950 lbs. model 157 N m (16kgf m/116lb ft) 2.
Install the speed sensor and take care not to hit the speed sensor during installation. 3. Install the speed sensor fixing bolt and tighten it to the specified torque. Torque: 18 N m (1.8kgf m/13lb ft) 4. Install brake drum and tighten bolts to the specified torque. Torque: 13 N m (1.3kgf m/9.5lb ft) 5. Connect speed sensor connector. NOTE: Confirm that the harness is not twisted when connecting the speed sensor connector. Legend (1) Speed Sensor Connector (2) Front (3) Speed Sensor (4) Rear Axle 1. Disconnect speed sensor connector. 2. Remove brake drum. 3. Remove speed sensor fixing bolt. 4. Remove speed sensor. 5. Remove speed sensor bracket.