5A4-66 ANTI-LOCK BRAKE SYSTEM (ABS) 5. Install hub assembly onto the axle case. 6) Rotate the hub several times to the right and left. 7) Measure the bearing preload a second time. 6. Set the lock nut with the notched line facing out. Preload Adjustment 1) Turn the hub to the left and right several times to establish bearing conformity. 2) Use the bearing nut wrench to tighten the bearing nut until the hub can not be manually rotated. 3) Loosen the bearing nut until hub rotates easily. 8) Align the axle case groove with the closest bearing nut slit. NOTE: If it is difficult to align the axle case and bearing nut, slightly tighten the bearing nut. 7.
Install the lock washer with the lock washer tabs inserted to the axle case grooves. Install the lock bolts to prevent the bearing nut from loosening. Check that the lock washer tabs are inserted to the axle case grooves. 8. Apply grease to the outer oil seal lip inner and outer circumferences and install outer oil seal. 9. Clean the axle shaft. Apply gear oil to the axle shaft spline. Insert the axle shaft into the axle case. Take care not to damage the oil seal. 10. Tighten the axle shaft nuts to the specified torque a little at a time. Torque: 46 N m (4.7kgf m/34lb ft) 11. Install brake drum. 4) Set the spring balancer to the wheel pin in the position shown in the illustration.
5) Measure the hub bearing preload by carefully pulling on the spring balancer and noting the indicator reading. Hub Bearing Preload (At Wheel Pin) 42-52 N (4.3-5.3kgf/9.4-11.6lbf)