. OPERATION OPERATION OPERATIONS AND CHECKS AFTER STARTING ENGINE WARNING the 3 - 100 If there has been any Em ergency stop, abnormal actuation or troubl e, turn the starting switch k ey to the OFF posi If the work equipment is o perated without sufficiently warming the m achine up, response of the work equipment to movement of the control lever will b e slow, and the work equipment may not respond as the operator de sires, so always p erform the warming-up operation.
P articularly in cold areas, be sure the warmi ng-up operation is complete CHECKING OF ENGINE STARTABILITY AND NOISE When starting the engine , check that the engine causes no abno rmal noise an d that it sta rts up easily and smoothly. Check also that there is no abnormal noise when the engine is idling or when the revolu tion rises slightl y. e may be When there is an ab normal noise at the engine startup a nd if that condition conti nues, the engin possible. damaged.
In that cas e, ask your Komatsu distributor to che ck the engine as soon as CHECKING OF ENGINE ACCELERATION AND DECELE RATION Check that there is no irre gularity in the engine speed and that th e engine does not sudde nly stop when the machine is stopped during normal travel. ne accelerates smoothly when the accelerator pedal is depressed. on in a safe place and check that there is no one in the surrounding area.
Check also that the engi ne accelerates smoothly when the acc elerator pedal is depress Carry out the inspecti on in a safe place and check that ther e is no one in t he surroun If the condition at low speed or when accelerating is extreme ly poor and tha t condition continues, there is danger that the engine may b e damaged, that the operating feeling may become strange, t hat the braking e ffect may deteriorate, or that an unexpected accident may happen, so please ask your Komatsu distributor to carry out ssible. repairs as soon as po BREAKING IN THE M ACHINE been thoroughly adjusted and tested before shipment from the factory.
However, op NOTICE Your Komatsu machine has machine under full load bef ore breaking the machine in can adversely affect the performance and shorten the machi Be sure to break in the mac hine for the initial 100 hours (as indicated o n the service m eter). Make sure that you fully u nderstand the content of this manual, a nd pay careful attention t o the following po ints when breaking in the machine. Run the engine at idle for 15 seconds after starting it. Durin g this time, do not operat e the control lev ers or fuel control dial. inutes after starting it up. eavy loads or at high speeds.
Idle the engine for 5 m inutes after starting it up Avoid operation with h Immediately after start ing the engine, avoid sudden starts, su dden acceleration, unne cessary sudden s tops, and sudden changes in dir ection.