Komatsu — OPERATIONS AND CHECKS AFTER STARTING ENGINE

. OPERATION OPERATION position between LOW run the engine at load until engine is within the green 5. Check for abnormal exhaust gas color, noise, or vibration. If any problem is found, contact your Komatsu distributor. 3 - 102 IN COLD ARE AS ARMING-UP OPERATION) equipped with an automatic warming-up device. gine is started, if the engine coolant temperature is low (below 30 °C (86 °F)), the warming-up arried out automatically. ic warming-up operation is canceled if the engine coolant temperature reaches the specified (AUTOMATIC W ARMING-UP OPERATION) This machine is equipped with an automatic When the en gine is started, if the engine operation is c arried out automatically.

ic warming-up operation is The automat specified temperature (30 °C (86 °F)) or if the war ming-up operation is continued for 10 minut es. If the engine c oolan temperature or hydraulic oil temperature a re low after the automatic warming-up opera tion, warm the engine up further as foll ows. 1. Turn fuel co ntrol dial (1) to the center po IDLE (MIN) medium spe and HIGH IDLE (MAX) an ed for about 10 minutes with 2. Operate bla de control lever (4) to the R keep the bla relieve the c 3. Finally, oper de raised to the maximum h eight and continue ircuit for 10 minutes. ate blade control lever (4) an to operate th If the oil te raised, ther equipment a 4.

After warm- up is completed, check gaug for proper o Continue to coolant tem range (B). (A): White ra (B): Green r (C): Red ran peration. If any problem is fo REMARK I f the power trai n oil temperature is not raise d sufficiently, it will take longer to accelerate to the maximum s peed.