Komatsu — ADJUSTING POSTURE OF WORK EQUIPMENT

. OPERATION OPERATION ADJUSTING POSTURE OF WORK EQUIPMENT WARNING BLADE ADJUSTMENT TILTING THE TILTDOZER 3 - 137 When adjust ing, it is dangerous if the work equipment is m oved by mistake. Set t he work equipm ent in a safe condition, then stop the engine a nd lock the work equ ipment securely with th e work equipment lock NOTICE m tilt is 1000 mm (39.4 in). lt so that it does not exceed the limit of 1000 mm (39.4 in). The maximu m tilt is 1000 mm (39. Adjust the ti lt so that it does not exceed the limit of 1000 mm (39.4 in).

If the maxim um tilt is exceeded, e xcessive force will be b rought to bea r on all p arts, and this wi ll damage the machine If it is nece ssary to have a lar ger tilt amount than c an be obtained by operatin g the blade control lever, do as follows. Use bar ha ndle (2) installed to the left brace to rotat e brace (1) a nd change br ace length ( l ). T his makes it possible to obtain a een the joints ( l ) is as follows. 0 mm maximum t ilt of 1000 mm. The stan dard distance betw een the joints ( l ) is as follows. Sigmad Semi U- ozer: 1403 mm dozer,U-dozer: 146 ADJUSTING SHIM IN BLADE CYLINDER CAP Set the sta ndard shim adjustm ent in the blade cylind er cap to 4 mm (0.16 in).

hims to balance the wear of the cap and the ball at the piston rod. Remove s hims to balance the wear of the cap and end of the piston rod. The proper clearance to be m aintained with the shi ms is 0.2 to 0.5 mm (0.008 to 0.02 in).