Komatsu — STARTING MACHINE AFTER LONG-TERM STORAGE

. OPERATION LONG-TERM STORAGE LONG-TERM STORAGE DURING STORAGE WARNING ventilation and prevent gas poisoning. AFTER STORAGE 3 - 152 BEFORE STORAGE than one month), store as follows. When keeping in long-term storage (more Clean and wash all parts, then store th e machine indoors. If the machine has to be store d outdoors, sel ect level ground and cover the machine with ca nvas. ents moisture from collecting. rage. rface of the hydraulic piston rods and the idler adjusting rods. the battery and cover it, or remove it from the machine and store it Completely fill the fuel tank.

This prev Lubricate and change the oil before sto Apply a thin coat of grease to metal su rface of the hydraulic piston rods and the idler adjustin Disconnect the negative terminals of separately. Place all control levers at the neutral p osition, set the work equipment lock lever and parking brake lev er to the lock the low idling position. position, and set the fuel control dial to To prevent rust, fill with Komatsu genui ne supercoolant (AF-NAC) to give a density of at le ast 3 0% for th e engine coolant.

If it is necessary to perform the rust-prevention operation while the machine is indoors, open the doors and windows to improve During storage, operate and move the machine for a short distance once a month so that a new film of oil will coat moving parts. At the same time, also c For machines equipped with an air con NOTICE If the machine has been stored without carryi ng out the monthly rust-prevention operation, consult your Komatsu d istributor before using it. When using the machine after long-term storage, do as follows before using it. cylinder rods. nts.

Wipe off the grease from the hydraulic Add oil and grease at all lubrication poi When the machine is stored for a long p eriod, moisture in the air will mix with the oil. Check the oil before and after starting the engine. If there is water in the oil, change all the oil. STARTING MACHINE AFTER LON G-TERM STORAGE When starting the engine after the machin e has been in storage for a long period, carry out the warming-up o peration thoroughly. For details, see the procedur e in "WARMING UP OPERATIONS (PAGE 3-101)".