Komatsu — HANDLING OIL, FUEL, COOLANT, AND PERFORMING OIL CLINIC

. MAINTENANCE OUTLINES OF SERVICE HANDLING OIL, FUEL, COOLANT, AND PERFORMING OIL CLINIC OIL Oil is used in the engine and hydraulic equipment under extremely severe conditions (high temperature, high pressure), and deteriorates with use. Always use oil that matches the grade and maximum and minimum ambient temperatures recommended in the Operation and Maintenance Manual. Even if the oil is not dirty, always change the oil at the specified interval. Oil corresponds to blood in the human body, always be careful when handling it to prevent any impurities (water, metal particles, dirt, etc.) from getting in. The majority of problems with the machine are caused by the entry of such impurities.

Take particular care not to let any impurities get in when storing or adding oil. Never mix oils of different grades or brands. Always add the specified amount of oil. Having too much oil or too little oil are both causes of problems. If the oil in the work equipment is not clear, there is probably water or air getting into the circuit. In such cases, please contact your Komatsu distributor. When changing the oil, always replace the related filters at the same time. We recommend you have an analysis made of the oil periodically to check the condition of the machine. For those who wish to use this service, please contact your Komatsu distributor.

When the machine is shipped from the factory,T010 (power train oil) is used for the hydraulic system. When using H046-HM hydraulic oil, drain all the oil and fill with the specified amount of oil. Always use oil recommended by Komatsu. If any other oil is used, it will cause clogging of the filter. There is no problem if the new oil is mixed with the small amount of oil remaining in the piping and cylinders. 4 - 5 OUTLINES OF SERVICE Alway s use Komatsu genuine parts for replacement parts, grease or oil. When changing the oi l or adding oil, do no t mix different types of o il. When changing the type o f oil, drain all the old oil and fi ll completely with the new oil.

Always replace t he f ilter at the same time. (There is no problem if the small a mou nt of oil remaining in the piping mixes with the new oil. Unless otherwise s pecified, the t ype of oil and coolant use d when the machine is shipped from the factory is as shown in the table b elow Item Type Engine oil pan Engine oil EO15W40DH (Komatsu genuine parts) Damper case Powertrain oil TO30 (Komatsu genuine parts) Power train oil pan Final drive case Hydraulic oil system Powertrain oil TO10 (Komatsu genuine parts) Radiator Supercoolant AF-NAC (density: 30% or above) (Komatsu genuine parts)