. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 4 - 52 (5) Ripper tilt cylinder b ottom pi (6) Ripper lift cylinder b ottom pi (7) Ripper tilt cylinder r od end p in (2 places) (8) Ripper lift cylinder r od end p in (2 places) (9) Ripper ar m pin (fron t) (2 pla (10)Ripper a rm pin (rea r) (2 pla The illustrati on on the r ight sho ws Giant Ripper (if equipped). (11 ) Equalize r bar side shaft (2 places) (12 ) Suspen sion (Equalizer bar center shaft ) (1 place) 1) Carry out greasing o f the sus pension (equalizer bar center shaft) through the grease fittin gs marked by arrows 2) Pump the greasing l ever up and down 3 t o 5 times.