Komatsu — EVERY 250 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK LEVEL OF BATTERY ELECTROLYTE Carry out this procedure before operating the machine. WARNING the NOTICE do month and The batteries are installed at (A) part. WHEN CHECKING ELECTROLYTE LEVEL FROM SIDE OF BATTERY If it is possible to check the electrolyte level from the side of the battery, check as follows. 1. Use a wet cloth to clean the area around the electrolyte level lines and check that the electrolyte level is between the UPPER LEVEL (U.L.) and LOWER LEVEL (L.L.) lines. If the battery is wiped with a dry cloth, static electricity may cause a fire or explosion. 2.

If the electrolyte level is below the midway point between the U.L and L.L lines, remove cap (3) and add distilled water to the U.L line. 3. After adding distilled water, tighten cap (3) securely. REMARK If distilled water is added to above the U.L. line, use a syringe to lower the level to the U.L. line. Neutralize the removed fluid with baking soda (sodium bicarbonate), then flush it away with a large amount of water or consult your Komatsu distributor or battery maker. 4 - 54 Do not use the battery if t he battery electrolyte level is below t he LOWE R LEVEL line. T his will accelera te deterioration of inside of the battery and r educe the service life of the battery.

In additio n, it may cause an explosion. the battery. The battery generates fla mmable gas and there is danger of e xplosion, do not bring fir e or sparks near Battery electrolyte is dang erous. If it gets in your eyes or on y our skin, wash it off with a large amount of water and cons doctor. When adding distilled wa ter to the battery, do not allow the battery electrolyte to go above the UPPER LEVEL line. If h, it may leak and cause damage to the paint surface or corrode other parts. electrolyte level is too hig h, it may leak and cause damage to the paint surface or corr ode other parts. If there is a fear that the batte ry water may freeze after refilling wit water (e.g.

commercially ava ilable replenishment water for a ba the replenishment before the Inspect the battery elect follow the basic safety pr Open cover (1), (2) at t rolyte level at least once a mo ocedures given below. he rear left side of the machi