. MAINTENANCE SERVICE PROCEDURE REPLACE CORROSION RESISTOR CARTRIDGE WARNING after 4 - 70 If the engine has been operated, a ll parts will be at a high temperatur e, so never try to replace the c stopping the e Always wait fo r the engine and oth er parts to coo Container to catch drained c Prepare a 1. Turn val ve (1) of corrosion resistor (2) to the CLOSE stop stop position. 3. Using a filter wrench, remo ve cartridge ( 4. Clean th e filter holder, coa t the packing surface and thread cartridge with oil, t hen install it t o the filte 5. When in stalling, tighten un til the packing surface contacts t he seal surface of the filter h 2/3 of a If the filt If the filte turn.
er cartridge is tight ened too far, the packing will be damaged and this will lead r cartridge is too lo ose, coolant will also l eak from t he packing, so always tighte 6. Open va lve (1). 7. After rep lacing the cartridg e, start the e ngine and check fo r any coolant leakage from t there is any leakage, chec k if the cartrid ge is tightened pro perly .