3. Take the filter element out of the cleaning liquid and flush it with running water. The water pressure should be less than 274 kPa. 4. Dry the filter element at a place with good ventilation. Use a fan for quick drying. Note: Never use the compressed air or open fire for quick drying. It may result in damage of filter element. Generally, it will take two to three days to completely dry a filter element. In this case, a standby should be prepared for temporary use. 1.4.2 Lubricant system Main oil filter (paper filter element) Replace procedure 1. Loosen the oil drain plug to drain out the oil. 2. Several minutes later, retighten the oil drain plug. 3.
Unscrew the used filter counter-clockwise with a filter wrench. 4. Clean the fitting surface of oil cooler to ensure suitable fitting with the new oil filter. 5. Apply a thin layer of oil to the O-ring. 6. Screw in the new oil filter until the filter O-ring makes perfect contact with the sealing surface. 7. Further screw in the filter by 1+1/4 turn with a filter wrench. Filter wrench: 1010300FA-9101 27