General Information 00 M2 Maintenance Interval Operations: 00–05 M2 Maintenance Interval Operations for Service Schedules I, II, and III Maintenance Operation Number Schedule I: every 5000 miles (8000 km) or 500 hours Check Schedule II: every 50,000 miles (80 000 km) Schedule III: every 100,000 miles (161 000 km) 83–02 Air Filter Replacement * * Replace the HVAC filters every 6 months regardless of mileage, more often if the vehicle is operated under extreme conditions. Table 8, M2 Maintenance Interval Operations for Service Schedules I, II, and III Maintenance Operation Number M2 Maintenance Interval Operations for Service Schedule IV Schedule IV:
every 100,000 miles (161 000 km) Check 00–04 Perform All M1 Operations 01–01 Engine Drive Belt Inspection 15–01 Alternator, Battery, and Starter Connections Check 20–01 Pressure Relief Cap Check 20–03 Fan Clutch Check (noise emission control) 25–02 Clutch Release Cross-Shaft Lubrication 26–02 Transmission Fluid Level Inspection 26–03 Manual Transmission Air Filter/Regulator Check, Cleaning, or Replacement 32–01 Suspension Inspection 32–03 Suspension U-Bolt Torque Check 33–02 Knuckle Pin Lubrication, Meritor Axles 33–03 Tie Rod Inspection 33–05 Tie Rod Lubrication, Meritor Axles 35–02 Axle Breather and Axle Lubricant Level Inspection 40–01 Wheel Nut Check 41–01 Driveline Inspection 41–02 Driveline Lubrication 42–01 Air Brake System Valve Inspection 42–03 Air Dryer Inspection 42–04 Alcohol Evaporator Cleaning and Inspection 46–01 Drag Link Inspection 46–03 Power Steering Fluid Level Inspection 46–04 Power Steering Gear Lubrication 46–05 Drag Link Lubrication 47–01 Fuel Filter Replacement 47–02 Fuel/Water Separator Element Checking and Replacement 60–01 Mirror Folding Check 83–01 Air Conditioner Inspection 122SD and Coronado 132 Maintenance Manual, February 2016 00/12