Alternators and Starters 15 15–00 Safety Precautions 5. Check that all electrical connections at the alter- nator and starter are free of corrosion. Clean and tighten all charging system electrical connec- tions, including the connections at the starter B terminal and ground terminal, the magnetic switch, and where the alternator charging cable terminates. Apply red dielectric enamel to all ex- posed connections. Safety Precautions in this section apply to all procedures within this group. DANGER When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires.
Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death. 6. Inspect the battery retainer assembly or hold- downs, and the battery box. Replace worn or damaged parts. Remove any corrosion with a wire brush, and wash with a weak solution of baking soda and water. Flush with clean water, and dry. Paint the retainer assembly if needed, to prevent rusting. 15–01 Alternator, Battery, and Starter Connections Check 7. Check that foreign material, such as road debris, is removed from the battery box. 8.
Inspect and clean the battery cables, terminals, and clamps as follows. See Group 54 of the 122SD and Coronado Workshop Manual for troubleshooting instructions, and for adjustment, repair, or replacement instructions. WARNING Batteries generate explosive gas as a by-product of their chemical process. Do not smoke when working around batteries. Put out all flames and remove any source of sparks or intense heat in the vicinity of the battery compartment. Make sure the battery compartment has been completely vented before disconnecting or connecting the battery cables. 8.1 Inspect the battery cables, and replace any that are damaged.
8.2 Clean and tighten the battery ground cables, terminals, and clamps. Clean the cable connector terminals with a wire brush. 8.3 Connect the cables to the batteries and tighten them to the torque specifications listed on the battery, generally 10 to 15 lbf·ft (14 to 20 N·m). Battery acid is extremely harmful if splashed in the eyes or on the skin. Always wear a face shield and protective clothing when working around batteries. 8.4 Coat the battery terminals with dielectric grease. 1. Disconnect the batteries. 2. Check the tightness of the alternator fasteners; tighten as needed. For torque values, see Group 15 of the 122SD and Coronado Workshop Manual . 9.
Check the connections at the power net distribu- tion box. Clean and protect the power cables with dielectric enamel as necessary. 3. Inspect the alternator drive belt for cracking, glazing, and wear; see Group 01 . Replace the belt if it shows any of these symptoms. NOTE: Engines equipped with a serpentine belt have automatic belt tensioners, and do not re- quire belt tension adjustment. 4. Check the alternator wiring for missing insulation, kinks, and heat damage. Replace or repair as needed. 122SD and Coronado 132 Maintenance Manual, February 2016 15/1