Freightliner — 122SD, Coronado 132

Transmission 26 26–00 Safety Precautions venient steel slug to short the two magnetic poles and divert the magnetic field. Safety Precautions in this section apply to all procedures within this group. Install and tighten each drain plug 50 lbf·ft (68 N·m). DANGER NOTE: The optional transmission fluid filter is a remote-mount, spin-on type, and is located be- tween the transmission and the fluid cooler. The filter bracket is attached to the frame rail or some other nearby location. The filter is mounted in a vertical position, and should be filled with fluid before installation to assure the proper fluid level.

For optimum transmission per- formance, change the filter each time that the fluid is changed. When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death. 26–01 Eaton Fuller Transmission Fluid Change, and Magnetic Plug Cleaning 6. For a transmission equipped with a transmission fluid filter(s), replace the fluid filter(s) as follows. 6.1 Place a drain pan under the transmission fluid filter.

CAUTION NOTICE To prevent skin burns from hot transmission fluid, wear protective gloves when removing the filter. Operating a transmission with the fluid level higher or lower than recommended can result in transmission damage. Do not overfill the transmis- sion. Overfilling will force fluid out of the case through the main shaft openings. 6.2 Place a strap or chain wrench around the filter canister, and rotate it in a counter- clockwise motion to separate the filter from the mounting. Carefully spin the filter off the mount and remove it from the ve- hicle. Do not mix types and brands of fluid, because of possible incompatibility.

Do not use fluid addi- tives, friction modifiers, extreme-pressure gear fluids, or multiviscosity lubricants. 6.3 Apply a light coat of transmission fluid to the O-ring gasket on the new filter. Fill the filter with specified transmission fluid, and spin the filter onto the mount. NOTE: Fluid change intervals are extended to 500,000 miles (800 000 km) on any vehicles filled with synthetic transmission fluid. NOTE: The filter fills slowly, so be patient to ensure the proper fluid level has been reached. 1. If the transmission fluid is not at normal operat- ing temperature, run the engine until the fluid reaches operating temperature. 2.

Park the vehicle on level ground, apply the park- ing brakes, shift the transmission to neutral (N), shut down the engine, and chock the tires. 6.4 Once the filter makes contact with the mount, use a strap wrench to rotate the canister an additional 180 to 270 degrees to firmly tighten the filter. Wipe the filter clean of any fluid after it is tightened. 3. Place a large drain pan under the transmission. 4. Clean the area around the fill plug, and remove it from the side of the gear case. Remove each drain plug from the bottom of the case. 7. Add fluid until it is level with the lower edge of the fill opening. See Fig. 1 .

If the transmission has two fill openings, add fluid to the level of both openings. See Table 1 for approved trans- mission lubricants. See Table 2 for Eaton Fuller transmission lubricant capacities. 5. Clean the fill and drain plugs. For magnetic plugs, use a piece of key stock or any other con- 122SD and Coronado 132 Maintenance Manual, February 2016 26/1