Freightliner — 122SD, Coronado 132

Transmission 26 1. Park the vehicle on a level surface, apply the parking brakes, and chock the tires. If the fluid level is within the COLD RUN band, the transmission may be operated until the fluid is hot enough to perform a hot check. 2. Clean the area around the fill plug, then remove the plug from the side of the gear case. If the fluid level is not within the COLD RUN band, add or drain fluid as needed to adjust the fluid level to the middle of the COLD RUN band. See Fig. 2 . 3. Using your finger or a bent pipe cleaner, check if the fluid is level with the fill opening. See Fig. 1 . 4. If the fluid level is low, check the transmission for leaks, and correct as needed. 5.

If needed, add recommended fluid until it is level with the lower edge of the fill opening. See Table 1 for approved transmission fluids. B 6. Clean the fill plug, then install it. Tighten the plug as follows: A 25 to 35 lbf·ft (34 to 48 N·m) for transmis- sions with 3/4-inch pipe threads. 60 to 75 lbf·ft (81 to 102 N·m) for transmis- sions with 1-1/4-inch pipe threads. Allison Cold Check 12/01/97 A. Cold Run Band B. Hot Run Band f270002a Fig. 2, Dipstick Markings NOTICE Clean all dirt from around the end of the fluid fill tube before removing the dipstick. Do not allow foreign matter to enter the transmission.

Dirt or foreign mat- ter in the hydraulic system may cause undue wear of transmission parts, make valves stick, and clog pas- sages. As the fluid temperature increases, so does the fluid level. Do not fill above the COLD RUN band if the transmission fluid is below normal operating temperature. NOTE: Perform a hot check at the first opportu- nity after the normal operating temperature, 160 to 200°F (71 to 93°C), has been reached. It is important to check the fluid level cold to deter- mine if the transmission has a sufficient amount of fluid to be safely operated until a hot check can be performed. Hot Check 1. Park the vehicle on a level surface, apply the parking brakes, and chock the tires. 1.

Park the vehicle on a level surface, apply the parking brakes, and chock the tires. 2. Shift the transmission to NEUTRAL. 2. Run the engine for at least one minute. 3. Operate the engine at idle (500 to 800 rpm) until normal operating temperature is reached. Check that the sump temperature is 160 to 200°F (71 to 93°C). Check that the converter-out temperature is 180 to 220°F (82 to 104°C). 3. Shift from DRIVE to NEUTRAL, and then shift to REVERSE to fill the hydraulic system. 4. Shift to NEUTRAL and allow the engine to idle at 500 to 800 rpm. 5. With the engine running at idle, remove the dip- stick from the tube and wipe it clean. 4.

With the engine idling, remove the dipstick from the tube and wipe it clean. 6. Insert the dipstick into the tube, then remove it. 5. Insert the dipstick into the tube, then remove it. 6. Check the fluid level reading, then repeat the check procedure to verify the reading. Safe oper- ating level is within the HOT RUN band on the 7. Check the fluid level reading, then repeat the check procedure to verify the reading. 122SD and Coronado 132 Maintenance Manual, February 2016 26/3