Freightliner — 122SD, Coronado 132

Transmission 26 10. Align each cover assembly with the holes in the channel plate sump, and push the cover assem- blies in by hand to seat the seals. NOTICE Do not use the bolts to draw the filter covers to the sump. This can damage the covers, seals, or sump. 11. Install six bolts in each cover, and torque the bolts 38 to 44 lbf·ft (51 to 61 N·m). 12. Replace the drain plug O-ring, then install the drain plug. Tighten the drain plug 18 to 24 lbf·ft (25 to 32 N·m). 13. Refill the transmission with fresh automatic trans- mission fluid and check the fluid level. See Table 3 for transmission lubricant capacities, and Table 4 for approved transmission lubricants.

Allison 4000 Series Transmission Lubricant Capacities * Sump Size Refill Capacity : qt (L) 4 Inch 39 (37) 2 Inch 31 (30) * Quantities listed are approximate. Add listed amount of fluid, then perform a "hot check" and add fluid as needed. Do not overfill. Add 3 qt (2.8 L) for transmissions with PTO. Table 3, Allison 4000 SeriesTransmission Lubricant Capacities Allison Approved Automatic Transmission Lubricants Transmission Lubricant Type * Castrol TranSynd (synthetic) or other Allison Approved TES 295 Fluid Allison 4000 Series Allison Approved TES 389 Fluid or Dexron®-VI IMPORTANT: For TES 389 and Dexron-VI, use maintenance interval M1. * Lubricants listed in order of preference.

Do not mix fluid types. Call 1-800- 252-5283, or see www.AllisonTransmission.com for a complete list of Alli- son approved lubricants. Dexron-VI may only be used in units beginning with S/N 6610220990. Table 4, Allison Approved Automatic Transmission Lubricants 122SD and Coronado 132 Maintenance Manual, February 2016 26/6