Rear Axle 35 Two-Speed Axles With Shift Unit Dana Spicer and Meritor IMPORTANT: Also do the appropriate procedure under the heading "All Axle Models." NOTICE Failure to keep lubricant at the specified level could cause damage to the axle shift unit. 1. Clean the shift unit oil fill plug, and the area sur- rounding the plug. See Fig. 6 . Turn the fill plug counterclockwise to remove it. 2. Insert a finger or pipe cleaner into the fill plug hole and check the fluid level. The lubricant should be level with the bottom of the fill hole. If low, add the recommended lubricant. NOTICE Before adding additional lubricant, make sure of the type currently in the shift unit.
To prevent component damage, do not mix engine oil with automatic transmission fluid. IMPORTANT: When the ambient temperature is above 0°F (–18°C), use SAE 10 heavy-duty en- gine oil, API service classification SD (sulfated ash content must not exceed 1.85%). When the ambient temperature is below 0°F (–18°C), use one part kerosene to three parts SAE 10 heavy- duty engine oil, API service classification SD (sulfated ash content must not exceed 1.85%). This cold-weather mixture can be safely used up to 32°F (0°C). Commercially available automatic transmission fluid may be used in place of SAE 10 engine oil. Automatic transmission fluid can be used for all temperatures; do not mix it with kerosene.
3. Coat the threads of the fill plug with a small amount of Loctite® 242, or equivalent sealant. Install the fill plug finger-tight in the rear axle shift unit housing. Using a wrench, tighten it an addi- tional 1-1/2 turns. 122SD and Coronado 132 Maintenance Manual, February 2016 35/9