Wheels and Tires 40 40–01 Wheel Nut Check breakage, and extreme tire tread wear. Excessive wheel nut torque can break studs, damage threads, and crack discs in the stud hole area. Use the recommended torque values, and follow the tightening sequence shown in Fig. 1 . IMPORTANT: After a wheel has been installed, the wheel nut torque must be rechecked after 50 to 100 miles (80 to 160 km) of operation. See Table 1 for disc wheel nut torque specifications, and see Fig. 1 for the wheel nut tightening se- quence. When checking stud-piloted rear dual disc wheels with inner and outer nuts, remove one outer nut at a time, tighten the inner nut, then reinstall and tighten the outer nut.
Repeat this procedure for all wheel nuts, using the tightening sequence shown in Fig. 1 . NOTICE Insufficient wheel nut (rim nut) torque can cause wheel shimmy, resulting in wheel damage, stud Description Nut Size Wheel Manufacturer Torque: lbf·ft (N·m) Disc Wheel Fastener Torques 10-Hole and 8-Hole Hub-Piloted Disc Wheel With Two-Piece Flange Nuts * Front and Rear Wheel Nut M22 x 1.5 All 450–500 (610–678) Front Wheel Nut 1-1/8–16 All 450–500 (610–678) 10-Hole Stud-Piloted Disc Wheel With Inner and Outer Nuts Rear Wheel Inner Nut 3/4–16 All 450–500 (610–678) Rear Wheel Outer Nut 1-1/8–16 All 450–500 (610–678) * Torque values for hub-piloted wheels are given for lubricated threads.
Lubricate threads with SAE 30W engine oil. Do not apply thread lubricant to ball seats of the nuts and wheels. Wipe it off if it is applied accidentally. Torque values for stud-piloted wheels are given for clean, dry threads. Table 1, Disc Wheel Fastener Torques Maintain the proper pressures for carried loads, per the tire manufacturers’ recommendations, or the tire pressure label on the driver’s door. 1 2 1 10 8 7 4 6 3 Have the wheel alignment checked after the first 10,000 miles (16 000 km), then every 40,000 miles (60 000 km) thereafter. 5 6 5 4 8 3 9 2 7 Do not continue to drive the vehicle if tires develop any of the following: A B 09/18/2001 A. 8-Stud Disc Wheel B.
10-Stud Disc Wheel f400164 blisters; cuts or punctures that reach to the cord; Fig. 1, Wheel Nut Tightening Sequence a nail, screw, rock, or other puncturing object; 40–02 Tire Check flat spots or irregular wear; Tires should be inspected closely during the first 3000 to 10,000 miles (5000 to 16 000 km) for abnor- mal wear. tread worn to a minimum depth; inability to maintain proper tire pressure. 122SD and Coronado 132 Maintenance Manual, February 2016 40/1