OPERATION OPERATION 1. Pull fuel control lever(1) to a position midway between the low idling and full speed positions, run the engine at a mid-range speed, and continue to run under no load for approx. 10 minutes. 2. Operate blade control lever(3) fully to the RAISE position, then hold the lever in position, and operate slowly to the left tilt relief and right tilt relief in turn for 5 minutes. 3. After this, operate the blade control lever(3) fully to the RAISE position, hold the lever in position, and relieve the left and right tilt intermittently.
Next, operate the lever to the LOWER position and lower the blade to the ground, then operate the lever fully to the FLOAT position, hold the lever in position, and relieve the left and right tilt in turn intermittently for 5 minutes. 4. After warm-up run is completed, check gauges and cau- tion lamps for proper operation. If any abnormality is found, repair it. Continue to run the engine at light load until engine water temperature gauge(2) falls within the white range. 5. Check that there is no abnormal exhaust gas color, noise, or vibration. If any abnormality is found, repair it. 3-61