TRANSPORTATION OPERATION When lifting the machine, stop it on a level place, then observe the following procedure. 1. Stop the engine and set the brake lock lever to the LOCK position. 2. Install wire ropes, slings, etc. matched to the weight of the machine to the lifting points as shown in the above figure. NOTICE G Use protectors, etc. so that the wire ropes will not be broken at sharp edges or narrow places. G Use sleds and bars having sufficient width so that they will not touch the machine. 3.
After setting the wire ropes, lift up the machine and stop at 100 to 200mm (3.9 to 7.9in) above the ground, and check that the wire ropes are not slack and the machine is horizontal, then lift up slowly. 3-96