Komatsu — OTHER TROUBLE

OPERATION TROUBLESHOOTING ENGINE G ( ): Always contact your Komatsu distributor when dealing with these items. G In cases of abnormalities or causes which are not listed below, please contact your Komatsu distributor for repairs.

3-109 Problem Main causes Remedy Engine oil pressure caution lamp remains alight when engine speed is raised after completion of warm-up G Engine oil pan oil level is low (sucking in air) G Clogged oil filter cartridge G Defective tightening of oil pipe joint, oil leakage from damaged part G Defective caution lamp G Add oil to specified level, see CHECK BEFORE STARTING G Replace cartridge, see EVERY 250 HOURS SERVICE ( G Check, repair) ( G Replace) Steem is emitted from top part of radiator (pressure valve) G Cooling water level low, water leakage G Loose fan belt G Dirt or scale accumulated in cool- ing system G Clogged radiator fin or damaged fin G Defective thermostat G Loose radiator filler cap (high altitued operation) G Defective water temperature gauge G Add cooling water, repair, see CHECK BEFORE STARTING G Adjust fan belt tension, see EVERY 250 HOURS SERVICE G Change cooling water, clean inside of cooling system, see WHEN REQUIRED G Clean or replace, see WHEN REQUIRED ( G Replace thermostat) G Tightening cap or replace pack- ing ( G Replace water temperature gauge) Indicator of water temperature gauge is in red range on right side of gauge Indicator of water temperature gauge is in white range on left side of gauge G Defective thermostat G Defective water temperature gauge ( G Replace thermostat) ( G Replace water temperature gauge) Engine dose not start when starting motor is turned G Lack of fuel G Air in fuel system G Defective fuel injection pump or nozzle G Starting motor cracks engine slug- gishly G Glow signal dose not glow red G Defective compression G Defective valve clearance G Add fuel, see CHECK BEFORE STARTING G Repair place where air is sucked in ( G Replace pump or nizzle) G See ELECTRICAL SYSTEM G See ELECTRICAL SYSTEM ( G Adjust valve clearance) Exhaust gas is white or blue G Too mach oil in oil pan G Improper fuel G Add oil to specified level, see CHECK BEFORE STARTING G Change to specified fuel Exhaust gas occasionally turns black G Clogged air cleaner element G Defective nozzle G Defective compression G Clean or replace, see WHEN REQUIRED ( G Replace nozzle) ( G Adjust valve clearance) Combustion noise occasionally makes breathing sound G Defective nozzle ( G Replace nozzle)