Komatsu — OUTLINE OF OIL, FUEL, COOLANT

OUTLINE OF SERVICE MAINTENANCE COOLANT G River water contains large amounts of calcium and other impurities, so if it is used, scale will stick to the engine and radiator, and this will cause defective heat exchange and overheating. Do not use water that is not suitable for drinking. G When using anti-freeze, always observe the precautions given in the Operation and Maintenance Manual. G Komatsu machines are supplied with Komatsu original anti-freeze in the coolant when the machine is shipped. This anti-freeze is effective in preventing corrosion of the cooling system. The anti-freeze can be used continuously for two years or 4000 hours. Therefore, it can be used as it is even in hot areas.

G Anti-freeze is flammable, so be extremely careful not to expose it to flame or fire. G The proper mixing proportion of the antifreeze depends on the ambient temperature. For the mixing propor- tion, see "CLEAN INSIDE OF COOLING SYSTEM (PAGE 4-23)". G If the engine overheats, wait for the engine to cool before adding coolant. G If the coolant level is low, it will cause overheating and will also cause problems with corrosion from the air in the coolant. GREASE G Grease is used to prevent twisting and noise at the joints. G The nipples not included in the MAINTENANCE section are nipples used when overhauling, so they do not need grease.

If any part becomes stiff or generates noise after being used for a long time, grease it. G Always wipe off all of the old grease that is pushed out when greasing. Be particularly careful to wipe off the old grease in places where sand or dirt sticking in the grease would cause wear of the rotating parts. STORING OIL AND FUEL G Keep indoors to prevent any water, dirt, or other impurities from getting in. G When keeping drum cans for a long period, put the drum on its side so that the filler port of the drum can is at the side. (To prevent moisture from being sucked in) If drum cans have to be stored outside, cover them with a waterproof sheet or take other measures to protect them.

G To prevent any change in quality during long-term storage, be sure to use in the order of first in - first out (use the oldest oil or fuel first). 4-6