Komatsu — ADJUSTING TENSION OF CENTER BRACE

MAINTENANCE SERVICE PROCEDURE ADJUSTING TENSION OF CENTER BRACE (Power tiltdozer only) When the blade assembly is removed for transportation, the tension of the center brace must be adjusted when the blade is assembled again. If the tension is not adjusted, the bushing at the blade and straight frame mount will come out, and soil will enter. This will result in damage or premature wear of the bushing. ADJUSTMENT Except when operating the blade in Step 4, always lock the blade control lever securely with the safety lock lever. 1. Adjust with shim(2) so that the play of ball joint(1) is 0.2 to 0.5mm (0.008 to 0.020in). 2. Loosen bolt(3). 3. Install the blade assembly. 4.

Operate the blade control lever to float the blade. 5. Insert a bar in hole(4) in the center brace, and turn it in the direction of protrusion. When doing this, adjust so that clearance D between the track and frame is the same on the left and right sides. Rotating torque: 24.5 to 49N•m (2.5 to 5kgf•m, 18.1 to 36.2lbft) (Blade at FLOAT) Standard distance ( ) between joints is shown below. D61EX: 758mm (29.9in) D61PX: 766mm (30.2in) 6. Tighten bolt(3). Tightening torque: 441 ± 49N•m (45 ± 5kgf•m, 325 ± 36lbft) 4-31 WARNING