Komatsu — LUBRICATING

MAINTENANCE SERVICE PROCEDURE EVERY 50 HOURS SERVICE DRAIN WATER, SEDIMENT FROM FUEL TANK 1. Drain water and sediment before starting the machine. 2. Prepare a container to receive fuel to be drained. 3. Open drain valve(1) at the bottom of the tank to drain sediment and water accumulated on the bottom, together with fuel. At this time, take care not pour fuel over yourself. 4. After clear fuel comes out, close drain valve(1). LUBRICATING 1. Lower the blde to the ground, then stop the engine. 2. Using a grease pump, pump in grease through the grease fittings shown by arrows. 3. After greasing, wipe off any old grease that was pushed out.

POWER ANGLE, POWER TILTDOZER (1)Frame center ball (1 place) 4-41