MAINTENANCE SERVICE PROCEDURE POWER TILTDOZER (1)Lift cylinder bottom pin (2 places) (2)Lift cylinder head pin (2 places) (3)Lift rod (4 places) (4)Center brace ball joint (2 places) (5)Tilt brace ball joint (1 place) (6)Tilt brace thread (1 place) (7)Lift lever mounting pin (4 places) (8)Tilt cylinder ball joint (1 place) GREASE EQUALIZER BAR SIDE PIN One place on each side of machine body 1. Remove all dirt from the top of the track frame and cover(1). 2. Clean the grease fitting indicated with the arrow, then supply grease to that fitting with a grease pump.
REMARK G Supply 3 shots of grease (Operate the grease pump lever 3 times) to each grease fitting, and check that grease is newly discharged through the seal lip. G If grease is not newly discharged through the lip, continue supplying grease until it is discharged. GREASE EQUALIZER BAR CENTER PIN (1 place) 1. Open the left side cover of the machine body. 2. Clean the grease fitting indicated with the arrow, then supply grease to that fitting with a grease pump. 4-43