MAN — Reworking valve seat

Reworking valve seat Fig. 4 Release the Jaccard lever, set the magnetic flange down flat on the clamping plate and adjust the height so that the forming cutter does not contact the valve seat. Set the toggle switch to position 1. Tighten the Jaccard lever. 4 Fig. 5 Machine the valve seat by turning the driving crank steadily in a clockwise direction and simulta- neously operating the feed nut. Caution: During the machining process, turn the crank vigorously and steadily but under no circumstances against the direction of turning as this may cause the carbide cutting edge to break off. 5 Fig.

6 Once the valve seat has been cleanly machined, reduce the working pressure of the forming cutter by 2−3 turns without feed motion. During these turns, turn the feed nut back 2−3 turns. Press the toggle switch briefly to position 2 to lift the magnetic field. Now move the entire Mira tool upwards and insert it in the next valve guide, repeating the centring operation. 6 Use the same cutter settings for all the intake and exhaust valve seats. 1 2 Fig. 7 Observe the specified seat angle. А Exhaust Б Intake 7 113