MAN — V-belts

V-belts Checking condition Fig. 1 D Check V-belts for cracks, oiling, overheating and wear D Change damaged V-belts 1 Checking tension 1 Figs. 2 and 3 Use belt tension indicator to check V-belt tension. D Lower the gauge arm А in the scale. D Position the tension indicator in the centre of the belt between the two pulleys so that the edge of the stop face Б locates against the side of the belt. D Slowly depress the pressure pad В vertically downwards until the spring disengages with an audible click; the gauge arm moves upwards. 2 2 A false reading will be obtained if you continue to apply pressure after the spring has disengaged. 3 3 Fig.

4 Taking tension reading D The tension is shown where the top of the gauge arm ( А in picture 2) intersects the kg scale. D Ensure that the gauge arm does not move be- fore you take the reading. If the reading does not correspond with the speci- fied value, the V-belt tension must be corrected. 4 146 Tensioning forces according to the kg graduation on the tester Drive belt New installation When ser- width Installation After 10 min. run- ning time vicing after long run- ning time 2/3VX 90−100 70−80 60