MAN — Removing and installing coolant pump

Removing and installing coolant pump Note: Exchange or repair coolant pump only if it has been found to be leaky. The design of the coolant pump mechanical cassette seal permits small amounts of coolant to pass through it. This coolant passing through results in a trace of drained coolant below the drain bore. This trace of drained coolant does not mean that the coolant pump has to be replaced. For this reason before exchanging or repairing a coolant pump ascertain D whether the cooling circuit shows visible and recurring signs of coolant loss; if yes D whether the coolant loss is caused by spillage from the expansion tank (e.g. too full) or by other leakages from hoses, radiator etc.

Coolant pumps must be exchanged only if coolant drips visibly while the engine is in operation or after the engine has been switched off. D Take off V−belt, see page 147 D Drain off coolant, see Page 43 D Remove expansion tank, see page 47 D Remove the thermostats, see page 46 Fig. 1 Unscrew coolant elbow to the exhaust gas pipe (arrow). 1 Fig. 2 Release the coolant pump mounting bolts and re- move the coolant pump. 2 Fig. 3 Clean the sealing faces on the coolant pump and crankcase with a scraper and fine abrasive paper. Stick the new gasket for the coolant pump housing to the crankcase with grease. Fit coolant pump. 3 48