11 [5] ASSEMBLY PROCEDURE ( 3) Installation of cab assembly 9) Temporary tightening of cab assembly mount- ing bolts • Necessary parts No. Part No. Part name Q'ty 1 01010-81240 Bolt 2 2 01643-31232 Washer 2 3 418-46-12310 Shim (t = 1.0) 4 4 01010-82050 Bolt 8 5 01643-32060 Washer 8 1. Drive 2 cab assembly mounting bolts (10) and 4 intermediate bolts and 4 rear bolts (11) (2 – 3 threads with your fingers). 1 each on 10) Move the steering post to the front end of the right and left side cab assembly and tighten the steering post [Caution] lower bolts which were loosened in step 4). Set bolts to bottom of oblong hole at part A and to top of oblong hole at part B.
(Set them as set when delivered.) 11) Lift down the cab assembly and tighten the steering post fixing bolts which were driven lightly in stop 8), and then tighten the bolts to fix to the floor. Precautions Special tools Necessary devices Name Q'ty Name Q'ty Other remarks ( 3) No. Part No. Part name Q'ty 1 01010-81240 Bolt 2 2 01643-31232 Washer 2 3 418-46-12310 Shim (t = 1.0) 4 4 01010-82050 Bolt 8 5 01643-32060 Washer 8