15 [5] ASSEMBLY PROCEDURE ( 4) Installation of ROPS canopy (4) INSTALLATION OF ROPS CANOPY 1) Removal of antenna 1. Remove the antenna from the right side of the cab assembly. Install screws (1) to the antenna mounting holes on the cab side to fill the holes. 2. Apply sealant (366E or equivalent) to the removed screws and install them again. 3. Draw in the antenna wire at least 100 mm. 2) Removal of rear frame ROPS support bolts tightened temporarily 1. Remove 4 bolts tightened temporarily into the right and left ROPS canopy mounting parts of the rear frame ROPS support. (Keep the bolts and washers to use again.) 2.
Check that the rear frame ROPS support mounting holes are matched to the holes on the floor. 3) Slinging of ROPS canopy 1. Sling the ROPS canopy with a 25-ton crane. Sling: Chain sling of spring hook type (2,000 mm x 4 pieces) Precautions Special tools Necessary devices Name Q'ty Name Q'ty Crane (25 ton) 1 Chain sling (2,000 mm x 4 pieces) 1 Other remarks ( 4)