20 [5] ASSEMBLY PROCEDURE (5 ) Installation of bucket 9) Installation of grease nipple and plug 1. Apply LM-G (lithium grease containing molybdenum disulfide) to the bucket hinge pin and bucket link pin. • Necessary parts No. Part No. Part name Q'ty 07049-01620 Bucket link pin 9 07020-00000 Bucket hinge pin 2 10) Measurement of steering wheel operating effort 1. Run the engine and raise the bucket to about 400 mm above the ground. 2. Remove the safety lock bar used to fix the front and rear frames and the chocks and release the parking brake. 3.
While running the engine at low idling (with no load on the bucket), pull the steering wheel knob with a push-pull scale in the tangential direction to check the operating effort. 4. After checking the operating effort, lower the bucket to the ground, apply the parking brake, stop the engine, set the safety lock bar to the frames, and set the chocks. Precautions Special tools Necessary devices Name Q'ty Name Q'ty Push-pull gauge 1 Other remarks (5 ) No. Part No. Part name Q'ty 07049-01620 Bucket link pin 9 07020-00000 Bucket hinge pin 2