honda — Service Information

YES - 1. Stop the engine and check the water intake screen for clogging. Is . the water intake screen clogged? NOTE: No problem if the overheat indicator light comes ON when restarting the engine after hot soak at high temperature, but comes OFF after idling for a few minutes ON while the engine is running Remove the foreign material and recheck. I NO c 2. Start the engine and check the cooling system indicator with the engine idling. Does cooling water constantly flow through the cooling system indicator? NO Check the discharge port for clog- ging, clean the discharge port if necessary. Check the water pump for wear or damage. Replace or repair the water pump.

Check the water tube for clogging or damage. Clean or replace the water tube if necessary. YES . ~ 3. Idle in gear for a few minutes to cool down the engine. Check the overheat indicator light. Does the overheat indicator light go OFF? YES w System is OK (engine temperature was high). NO J. 4. Check the thermostat. Is the ther- mostat good? NO Check the CDI unit (P. 16-1). 5. Disconnect the ECT (Engine coolant temperature) sensor 2P connector. Check the overheat indicator light. Does the overheat indicator light go OFF? 6. Check the ECT sensor (P. 16-3). Is the ECT sensor in good condition. NO Replace the ECT sensor. I YES i. 1 Replace or repair the wire harness. 2-1 0