honda — Service Information

BF40AoBF50A I From P. 2-1 1 I Remove the foreign material and 1 YES -w 4 1 1 recheck. J water intake screen for clogging. Is NO c Check the discharge port for clog- ging, clean the discharge port if necessary. Check the water pump for wear or damage. Replace or repair the water pump. Check the water tube for clogging or damage. Clean or replace the water tube if necessary. 3. Start the engine and check the cooling system indicator with the engine idling. Does cooling water constantly flow through the cooling system indicator? NO I YES ~ cool down the engine. Check the overheat indicator light. Does the overheat indicator light come OFF? System is OK (engine temperature was high).

Buzzer stops but overheat - I - Check the indicator light indicator light does not go Overheat indicator light ON (see base shop manual). mostat good? I YES 6. Disconnect the ECT (Engine coolant temperature) sensor 2P connector. Check the buzzer. Does the buzzer stop? Check the CDI unit (P. 16-1). YES c 7. Check the ECT sensor (P. 16-3). Is the ECT sensor in good condition. NO I YES f Check the thermostat. Replace the thermostat if necessary. Replace or repair the wire harness. 2-1 2