2. CARBURETOR SYNCHRONIZATION [l] SEALING WASHER (3) CAUTION Running the outboard motor without sufficient cooling water will damage the water pump and overheat the engine. Be sure that water flows from the cooling system indicator while the engine is running. If not, stop the engine and determine the cause of the problem. 1) Remove the engine cover. 2) Remove the 5 x 10 mm plugs and sealing washers from the intake manifold of each cylinder. 3) Attach the vacuum gauge adapters to each intake manifold plug hole and connect the vacuum gauge hoses to the adapters. Connect: The No. 1 vacuum gauge hose to the No. 1 vacu- um gauge adapter. The No. 2 vacuum gauge hose to the No.
2 vacu- um gauge adapter. The No. 3 vacuum gauge hose to the No. 3 vacu- um gauge adapter. 4) Attach an engine tachometer and restart the engine. Follow the tachometer manufacturer's instructions. Gzi] 111 VACUUM GAUGE ADAPTER \ 5 x 0.8 x 120L (3) 0751 0-30001 00 or 5) Run the outboard motor in an outboard test tank with the water at least 4 inches above the antiventilation plate. Allow the engine to warm up to normal operat- ing temperature (Approx. 10 minutes). Engine exhaust contains poisonous carbon monoxide gas that can cause unconsciousness and death. If the engine must be running, make sure the area is well ventilated. 6) Check the idle speed (See base shop manual).
VACUUMGAUGE (Commercially available) 3-2