BF40AoBFSOA 4) Adjust as follows, if necessary. [2] SHIFT PIVOT 5) Loosen the shift pivot lock nut, remove the 6 mm lock pin and 6 mm washer, and disconnect the throttle cable. 6) Turn the throttle grip to the fully open position and hold it in the position using the friction grip. 7) Remove the throttle rod pivot from the throttle cam. [4] 6 mm LOCK PIN 8) Pulling the throttle cable's shift pivot lightly, turn the shift pivot so that the throttle cable can be connected smoothly to the throttle arm that is set in the fully open position (i.e. throttle arm is lightly in contact with the fully open stopper).
11 1 SHIFT PIVOT 1 ' ' [l] SHIFT PIVOT 1 9) Connect the throttle cable to the throttle arm and tighten the shift pivot lock nut securely. THROTTLE ARM [4] FULLY OPEN I STOPPER 10) Install the throttle rod pivot on the throttle cam. 11) Turn the throttle grip to the fully closed position. Pushing the throttle arm lightly in the direction of arrow, check whether the center of throttle cam roller is at the right side (advancing side) to the reference marks. [4] REFERENCE [2] THROTTLE CAM MARKS \ ROLLER 3-7