honda — Fuel System

THROTTLE CAM/DASHPOT DIAPHRAGM r11 TORX BIT T30H (Commercially available 1) Place the dashpot diaphragm on the intake manifold, and loosely install the 6 x 16 mm torx bolts. 2) Apply grease to the sliding surface of the 6.7 x 12.5 x 24 mm collar and install it. 3) Install the opener cam return spring by aligning the hook with the boss of the intake manifold. 4) Install the throttle opener cam by aligning the hole with the dashpot diaphragm rod end and the groove with the opener cam return spring end. r31 DASHPOT DIAPHRAGM I 5) Align the point "A" of the assist spring with the groove in the throttle cam.

6) Set the projection of the assist plate in the hook of the assist spring and align the flat surface of the throttle cam with the tab of the assist plate. 7) Install the throttle cam, assist spring and assist plate on to the collar as an assembly. 8) Install the 6 mm washer and tighten the 6 x 40 mm flange bolt to the specified torque. 9) After assembly, adjust the dashpot diaphragm (P. 3- 4). 6 x 40 [16] 6 mm WASHER r11 THROTTLE CAM [15] THROTTLE CAM [14] ASSIST SPRING [2]HOOK [13] ASSIST PLATE [I21 ASSIST SPRING [31 THROTTLE OPENER CAM PROJECTION [ll] OPENER CAM ASSIST PLATE RETURN SPRING 191 6.7 x 12.5 x 24 mm COLLAR 5-1 9