honda — Throttle Bracket/Shift Lever/Handlebar (Tiller Handle Type Only)

BF40AoBFSOA Apply grease to the: - roller, shift arm pin and spring. - gear and roller sliding section of the shift gear. - bushing. - gear of the shift arm. Note the installation direction of the shift arm pin. Set the roller and shift gear in the neutral position as [3] SHIFT FRAME SIDE Install the shift gear and spring guide assembly with shown. SHIFT ARM PIN the shift arm set in vertical position as shown. [6] SPRING GUIDE & [9] SHIFT GEAWSPRING 171 GUIDE ASSEMBLY , SHIFT ARM \ - ' SHIFT FRAME Apply grease to the pivot point of the throttle arm. [l] 5 x 12 mm HEX BOLT (3) 121 THROTTLE ARM 4.5 N*m (0.45 kgf*m, 3.3 Ibf*ft) TORQUE:

4.5 N*m (0.45 kgFm, 3.3 IbM) Tighten the 5 x 12 mm hex bolt to the specified torque. [41 I ' a // 5 mm WASHER (3)' [31 GUIDE PLATE 15-1 2