BF40AoBF50A POWER TRIWILT SWITCH [2] POWER TRIWILT 131 SWITCH GROMMET \ / Power trim/tilt type only: Install the power tilt switch so that the "UP" mark is at the bracket bolt installation hole side (lower side) as shown, and install the switch grommet noting the direction. Power trimhilt type only: Replace the wire band with a new one, if it has been cut. After securing the wires with a new wire band, cut the end of the wire band so the projected end length is 10 - 20 mm (0.4 - 0.8 in). Tighten the 5 x 10 mm hex. bolt to the specified torque. Torque: 4.5 N*m (0.45 kgf*m, 3.3 Ibfuft) [4] "UP" MARK Power trim/tilt type only:
Check whether the power tilt switch wire does not interfere with the 5 x 8 mm hex bolt head. 131 *1 5 x 10 mm SCREW (2) 11 01 5 mm WASHER - & SWITCH BRACKET POWER TRlM/TlLT SWITCH SWITCH HOLE GROMMET 161 *1 SWITCH GROMMET 171 *1: Power Trim/Tilt Type *2: Gas assisted Tilt Type 15-1 4