honda — Throttle Bracket/Shift Lever/Handlebar (Tiller Handle Type Only)

B F40AoBF50A CONTROL CABLES, UNDER COVER Install the cable holder as shown noting the installation direction and tighten the 6 x 12 mm bolt washer to the specified torque. TORQUE: 0.7 Nom (0.7 kgfom, 5.1 Ibfa) Apply grease to the link pins of the throttle arm and shift arm, then connect the throttle cable and shift cable. Set the shift cable by aligning the groove of the cable with the cutout of the mounting point. Set the throttle cable by aligning the groove with the cutout of the cable holder. Route the throttle and shift cable through the grommet (upper hole: shift cable, lower hole: throttle cable) holes and set the grommet in the case correctly.

Power trimhilt type only:Check whether the power tilt switch wire does not interfere with the throttle cable. Tighten the cover screw to the specified torque. TORQUE: 2.2 N*m (0.22 kgfom, 1.6 Ibf*ft) [l] SCREW (6) I 2.2 N*m I [9] 4 mm E-CLIP (2)- 181 THROTTLE ARM - \ A 161 GROMMET [7] SHIFT ARM / 15-21