honda — Print

13. GAS ASSlSTEDlPOWER TILT I ~- ~ W P O W E R T R l M r r l LT ASSEMBLY 1. POWER TRlMRlLT ASSEMBLY b. DISASSEMBLY ZAUTION: [l] O-RING Do not disassemble the gear pump assembly. If it is faulty, replace it as an assembly. Do not use a shop towel, cloth, gloves, etc. Do not reuse the drained automatic transmis- sion fluid (ATF). Do not hold at the outer tube when holding the power trimhilt assembly in a vise during opera- tion. Clean the removed parts in fresh automatic transmission fluid (ATF), and blow each port of the parts with compressed air. Set the parts neatly in a suitable container with care not to contaminate them with dust and dirt. Do not reuse the O-rings oil seals.

Remove each valve and sleeve with care not to damage the sliding surface of the parts. ( D o n o t i \ L I [Z] OIL HOLE CAP [l] SCREW WASHER (4) POWER TRIM/TILT MOTOR 1) Connect the power trimhilt motor 2P connector and operate the power trimhilt motor assembly until the piston rod extends fully. [2] MOTOR ASSY. 131 \ MOTOR CORD BRACKET I 2) Loosen the manual valve fully. 3) Remove the oil hole cap and drain ATF in a suitable container through the bolt hole. 4) Remove the O-ring from the oil hole cap bolt and dis- card it. Replace the O-ring with a new one during reassembly. Do not drain ATF by pushing in the piston rod.

5) Open the two wire band clips and one wire band, and free the motor wire. 6) Remove the four screw washers, and remove wire protector and power trimhilt motor assembly. 7) Drain ATF from the valve body. 8) Remove the O-ring from the power trimhilt motor assembly and discard it. Replace the O-ring with a new one during reassem- bly. 9) Remove the drive joint from the gear pump assembly. \ [7] VALVE BODY I CLIP (2) 13-1