Armature 1) Check the armature for wear and damage. Replace if necessary. P I MICA 2) Visually inspect the commutator surface for dust, rust and other damage. If necessary, wipe it with a clean lint-free cloth or dress with a fine emery cloth. 3) Measure the mica depth. If the grooves are clogged, clean the grooves and measure the depth again. If the measurement is less than the service limit, replace the armature. Service limit 1.3 mm (0.05 in) 4) Check for continuity between each segment. If an open circuit exists between any two segments, replace the armature. 5) Check for continuity between the commutator and armature coil core. If continuity exists, replace the armature.
, I , I , / I , N?f 6) Check for continuity between the commutator and armature shaft. If there is continuity, replace the arma- ture. W 13-1 3