9) Apply ATF to the lower end of the cylinder and install the cylinder to the bottom piece. 121 OUTER TUBE , LOWER END 10) Set the cylinder/piston assembly vertically on the vise by holding the bottom piece. CAUTlO N : Take care not to tighten the vise too tight as it damages the bottom piece. 11)Pour the fresh ATF into the cylinder up to the top edge of the cylinder. 12)Apply ATF to a new O-ring, and install it in the groove in the outer tube taking care not to damage the 0- ring. [2] OUTER TUBE ir'y ir'y [2] OUTER TUBE 13-20