Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

29 Product Information Section General Information SEBU7645-06 A WARNING Table 6 930G Wheel Loader Approximate Weight 13027 kg (28720 Ib) Machine stability is affected by many factors, including the type of work tool and the position of a Maximum Length (B) 7390 mm (24.25 ft) work tool. Width Across Tires 2420 mm (95.2 inches) (A) | 3277 mm (129 inches) Machine stability and machine control can be significantly affected if a work tool is not installed. Height to Top of ROPS Operating a machine without a work tool can lead i02358665 Rated Load to loss of control or tipping of the machine which could result in serious injury or death.

When you operate a machine without a work tool, avoid the following conditions: SMCS Code: 6700 * excessive speed Bucket Rated Load sharp turns abrupt implement movement urations. Note: Rated loads should be used as a guide. The operator must be aware of the following conditions: e Work tools *« Uneven ground Soft ground e Failure to comply to the rated load can cause pos- sible personal injury or property damage. Review the rated load of a particular work tool before performing any operation.

Make adjustments to the rated load as necessary for non-standard config- slopes and uneven ground The rated operating load is defined by the SAE standard “J818” (May 1987) and by the “ISO 5998” (1986) as 50 % of the full turn static tipping load. The corresponding dump clearance is given for each bucket at maximum lift height and at a 45 degree dump angle. The reach is given for each bucket at maximum lift height and at a 45 degree dump angle. Clearance is measured from the ground to the bucket edge or to the tip of the bucket teeth. The reach is measured from the front tire to the bucket edge or to the tip of the bucket teeth.

« Other poor ground conditions a lilustration 16 g00628152 Dimension (A) represents the dump clearance. Dimension represents the reach. (B) 924G Rated loads are based upon a standard machine with the following conditions: « Implements