24. SERVICE PROCEDURE WARNING Hot, scalding coolant can spray out if the radiator cap is re- moved suddenly. Relieve system pressure by slowly turning the cap to the first notch or lifting the safety lever (if equipped). Re- move the cap only after the pressure is relieved. Prepare a container to catch drained coolant: Min 43.9 (l) (11.6 US gal, 9.7 UK gal) capacity. 1. If a corrosion resistor cartridge is installed, close valves a . 2. Turn radiator cap b slowly to remove it. 3. Remove the undercover, then set a container to catch the coolant under drain valve c . Open drain valve c at the bottom of the radia- tor to drain the water. 4.
After draining the water, close drain valve c and fill with city water. 5. Open drain valve c , run the engine at low idling, and flush water through the system for 10 minutes. When doing this, adjust the speed of filling and draining the water so that the radiator is always full. While flushing water through the system, watch carefully that the water inlet hose does not come out of the radiator water filler. 6. After flushing, stop the engine, open drain valve c , then close it again after all the water has drained out. 7. After draining the water, clean with a flushing agent. We recommend use of a Komatsu genuine cleaning agent.
For de- tails of the cleaning method, see the instructions given with the cleaning agent. 8. After cleaning, open drain valve c to drain all the cooling water, then close them and fill slowly with clean water. 9. When the water comes up to near the water filler port, open drain valve c , run the engine at low idling, and continue to run water through the system until clean colorless water comes out. When doing this, adjust the speed of filling and draining the water so that the radiator is always full. PC450-ENG 3-28