Komatsu — 24.1 INITIAL 250 HOURS SERVICE (ONLY AFTER THE FIRST 250 HOURS)

24. SERVICE PROCEDURE 24.2.3 CHECKING COOLANT LEVEL REMARK Check the coolant level before starting the engine. 1. Check the coolant level in the radiator reserve tank e . The coolant level should be between the FULL and LOW markings on the tank. 2. If coolant must be added, remove the reserve tank cap d and add coolant until level is between the FULL and LOW markings on the tank. DRAINING THE SYSTEM 1. Run the engine until it reaches operating temperature; then stop the engine 2. Remove the radiator cap as outlined in this section. 3. Do not remove the coolant filter. 4. Open the radiator drain valve. 5. Open the cab water heater valves, if equipped. 6.

Allow the system to completely drain into a suitable container. Do not let drain outlets plug up during draining. 7. Close the radiator drain valve. 8. Close the cab heater water valves, if equipped. 9. Do not allow the cooling system to dry out. PC450-ENG 3-30 WARNING • Before working on the engine or electrical system, disconnect the negative (ground) battery cable. Tag the cable and con- trols to warn against starting. • Wear hand and eye protection when draining hot fluids. WARNING