24. SERVICE PROCEDURE 24.2.9 REMOVAL OF THERMOSTAT ASSEMBLY Disconnect the cable from the negative - terminal of the battery. 1. Drain engine coolant. 2. Open engine hood, then remove alternator drive belt top cover. 3. Disconnect heater hose a , radiator upper hose b , and engine water temperature sensor connector c (CN-P7). 4. Remove adiabatic cover d , then remove thermostat housing e to- gether with thermostat f . # Remove front bottom bolt h of exhaust manifold g . 5. Remove thermostat f . INSTALLATION OF THERMOSTAT ASSEMBLY Carry out installation in the reverse order to removal. Refilling with water # Add water through the water filler to the specified level.
Run the engine to circulate the water through the system. Then check the water level again. FAN Check the fan for cracks, loose rivets (for metal fans) and bent or loose blades. Make sure it is securely mounted. Tighten the capscrews if loose. Replace damaged fans. PC450-ENG 3-33 WARNING Personal injury can result from a fan blade failure. Never pull or pry on the fan. This can damage the fan blade(s) and cause fan failure.