24. SERVICE PROCEDURE 24.8 EVERY 1000 HOURS SERVICE Maintenance for every 50, 100, 250 and 500 hours should be car- ried out at the same time. 24.8.1 CHANGE OIL IN SWING MACHINERY CASE Container to catch drained oil: Min. 21.5 l capacity. Refill capacity: 21.5 l (5.7 US gal, 4.7 UK gal). 1. Set an oil container under drain plug P under the machine body. 2. Loosen drain valve P under the body, drain the oil, then tighten the drain valve again. 3. Remove dipstick G and bleeding plug a . Add the specified amount of engine oil through gauge hole F . For details of the oil to use, see 20. “USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”, page 3- 12. 4.
After refilling, install bleeding plug a . 5. Wipe off oil on the dipstick with a cloth. 6. Insert dipstick G into the gauge pipe thoroughly and then pull it out again. 7. When the oil level is between the H and L marks, on dipstick G , it is normal. If the oil does not reach the L mark, add more oil through oil filler F . 8. If the oil level exceeds the H mark, drain the excess engine oil from drain plug P , and check the oil level again. PC450-ENG 3-68 WARNING The oil is at high temperature immediately after the machine has been operated. Wait for the oil to cool down before carry- ing out maintenance. WARNING