28. MACHINES READY FOR ATTACHMENTS 3. CONTROL PEDAL FOR ATTACHMENT This is used to operate the attachment. The pedal can be depressed to the front, neutral, and rear to operate the attachment as follows. Hydraulic crusher Hydraulic breaker Pedal front a : actuated Pedal front a : actuated Pedal neutral N : stopped Pedal neutral N : stopped Pedal rear b : reversed Pedal rear b : stopped For use of the pedals with other attachments, consult with the attach- ment manufacturer at the time of installation to determine the operation of the attachment and pedals. 4. LOCK PIN This locks the control pedal. Position a : Lock Position b : Pedal half-stroke position (oil flow 50%) Position c :
Pedal full-stroke position (oil flow 100%) When using the breaker, select the breaker mode on the monitor, and use position c . The oil flow at position b is smaller, so select it when using other attachments. Keep the lock pin in the LOCK position except when using the attach- ment. 5. ACCUMULATOR (FOR CONTROL CIRCUIT) This is installed to release any remaining pressure in the attachment circuit after the engine is stopped. Normally, do not touch it. PC450-ENG 5-6 WARNING The accumulator is charged with high-pressure nitrogen gas, and it is extremely dangerous if it is handled mistakenly. For details of handling, see “11.18 HANDLING ACCUMULATOR”. WARNING