12. OPERATION 2. Rear tilt Pull lever c up to adjust the angle of the rear of the seat. (5 stages) 1 ) To raise the angle at the rear of the seat, keep the lever pulled up and stand up slightly to remove your weight from the seat. 2) To lower the angle at the rear of the seat, keep the lever pulled up and apply your weight to the rear of the seat. Amount of tilt: Up 13°, down 13° 3) Adjusting seat height It is possible to move the seat up or down by combining adjustments 1 and 2. After setting the forward tilt or rear tilt to the desired height, operate the opposite part to set the seat horizontal then secure in position. Height adjustment: 60 mm (2.4 in) D:
Adjusting armrest angle Armrest d can be made to spring up by hand approx. 90°. In addition, by turning the bottom e of the armrest by hand it is pos- sible to make fine vertical adjustments of the armrest angle. Armrest ad- justment angle: 25° REMARK If the seat back is tipped to the front without raising the armrest, the armrest will rise automatically. E: Overall for-and-aft adjustment of seat Pull up lever f , set to the desired position, then release the lever. In this case, the operator’s seat, left and right control levers, and safety lock lever all slide together. Fore-and-aft adjustment: 120 mm (4.8 in) F:
Adjusting suspension (option) Turn knob g to the right to make the suspension harder, or to the left to make the suspension softer. Adjust the reading of the dial to match the operator’s weight and select the optimum suspension. REMARK To obtain the optimum adjustment, turn the knob so that the indicator of the weight display (kg) in the transparent portion of knob g is the same as the operator’s weight. ADJUSTMENT OF MONITOR PANEL ANGLE Turn the monitor panel so that the operator can view the monitor with ease. When adjusting the angle, the panel should be set to the desired position using both hands. The panel is automatically locked at that posi- tion. Amount of adjustment:
30° (stepless) PC450-ENG 2-45