Komatsu — 12.3 OPERATIONS AND CHECKS AFTER STARTING ENGINE

12. OPERATION 7. Turn fuel control dial a to the full speed (MAX) position and carry out the operation is Step 6 for 3 -5 minutes. 8. Repeat the following operation 3 - 5 times and operate slowly. Boom operation RAISE vn LOWER Arm operation IN vn OUT Bucket operation CURL vn DUMP Swing operation LEFT vn RIGHT Travel (Lo) operation FORWARD vn REVERSE REMARK In the above operation is not carried out, there may be a delay in response when starting or stopping each actuator, so continue the op- eration until it becomes normal. 9. Use working mode switch b on the monitor panel to select the working mode to be used. PC450-ENG 2-55